Moisture Separating System 800 CFM MODEL TX-MSS-800


This 800 CFM Moisture Separating System eliminates moisture from the compressor with four levels of separation.  No moving parts to maintain.  Deliquescent desiccant for added drying, has multiple outlets with auto exhaust ball valves and safety lock cables.  Uses a combination with additional manifolds or portable FRL system.  Has a200 PSI ASME Code tank.  All components from stainless, aluminum or galvanized steel.


The TX-MSS-800 has a 2 inch inlet with a screened 4 prong crowfoot fitting and a safety lock cable.  The system has four outlets.  One outlet is 2 inches with an OSHA compliant auto exhaust ball valve and a 4 prong crowfoot fitting.  Two outlets are equipped with 1 inch OSHA compliant auto exhaust ball valves and a 2 prong crowfoot fitting and the last outlet has a 3/4 inch OSHA compliant ball valve and a 2 prong crowfoot fitting.  All outlets have safety lock cables to limit the travel of erratic hoses in case of hose breakage or accidental disconnection.

The systems manifold tank has four additional outlet ports that can be configured with ball valves and crowfoot fittings.  A fifth outlet is utilized by the system and provides compressed air to the air mover which is used to pull ambient air through the aftercooler.  The aftercooler is the primary moisture separating component.  The ambient air is being pulled through the cooling fins of the aftercooler.  The rapid cooling of hot compressed air causes moisture vapor to condense into liquid.  The liquid then falls to the bottom of the deliquescent desiccant tank where it is expelled via the 1/2 inch ball valve on the bottom.  This valve is kept slightly open during operation to continually remove water from the system.

These systems are ideal for removing moisture prior to sand blasting or painting.  However, tey can also be used to remove moisture that can damage air tools like impact wrenches and grinders.  Tools can run off the additional outlet ports or additional manifolds can be used in conjunction with the moisture separator systems.  For example, a TX=2AMF, TX=4AMF or TX=5AMF can be connected via a 2 inch hose to the 2 inch outlet of the Moisture Separating System.  The manifolds provide a centralized distribution point, and because the compressed air has salready been cooled and the moisture has been removed, all downstream compressed air is dry.  Portable in line lubricator and filter/lubricators should be used with any air tool to provide lubrication during use.  Texas Pneumatic Hose Whip Assemblies can be configured for most applications.


There are no reviews yet.

Be the first to review “Moisture Separating System 800 CFM MODEL TX-MSS-800”

Your email address will not be published. Required fields are marked *